The following changes have occurred in the Loader firmware PCMflash:

 

1. Added new Module 65 VAG MED17/EDC17 CAN TP2.0/K-Linedesigned to work with ECU Bosch ME(D)17/EDC17 working on CAN Protocol TP2.0/K-Line. Supports recording via the diagnostic connector modified firmware, validation and correction checksums. Supported ECU MED17.1/17.1.1, ME(D)17.5/17.5.1/17.5.2/17.5.5/17.5.6/17.5.20, EDC17U01/U05, EDC17CP04/14/20/24 besides working together. Available archive the original firmware.

 

EDC17U01/U05/CP04/CP14 K-Line [VR/WR/CK]

ME17/MED17/EDC17 CAN TP2.0 [VR/WR/CK]

 

The module has no analogues available on the market.

 

2. Added new Module 66 Honda Boschdesigned to work with ECU Bosch installed in Honda cars. Supported ECU MED17.9.3, EDC17C58 (write after unlocking in BSL) as well as EDC17CP06, EDC17CP16 (recording without unlocking).

 

PGM-FI (Bosch EDC17CP06/EDC17CP16/2MB) [WR/CK]

PGM-FI (Bosch MED17.9.3/4MB) [Unlocked] [WR/CK] entry after unlocking the Module 53

PGM-FI (Bosch EDC17C58/4MB) [Unlocked] [WR/CK] entry after unlocking the Module 53

 

The module has no analogues available on the market.

 

3. In Module 47 Mitsubishi Gearbox CAN-bus added support for the TC-SST (Getrag 6DCT470), supported read, write, clone, and correction checksums.

 

TC-SST Getrag 6DCT470 [RD/WR/CK]

Getrag 6DCT470 Boot (MICRO) [RD/WR/CK]

Getrag 6DCT470 Boot (EEPROM) [RD/WR/CK]

 

The cost of the module changed and is was 10000 RUB.

 

New modules Editor firmware MasterEditPro: