In module 7 "Ford Transit/Tourneo/Ranger, Land Rover Defender", test support for the SID209 ECU with the KK2A hardware version has been added. It supports reading and unlocking in BSL mode, as well as writing via the diagnostic connector for the unlocked ECU.

In modules 35 "Toyota/Lexus/Scion/Hino" and 46 "Toyota/Lexus/Scion/Hino generation 2", a virtual reading function has been added for ECUs operating under the K-Line and CAN-bus protocol. Among the available files in module 46 are about 120 original ones from "unreadable" ECUs, for which updates have never been released.

Module 51 "China" adds support for the Delphi MT62.1U ECU installed in Great Wall cars, the Delphi MT95.1 ECU installed in GAC cars, as well as the Delphi MT62.1 ECU installed in Huanghai cars. Read, write, and checksum correction are supported.

The Renault/Nissan UDS module 59 has added support for the SID310 ECU variant used in hybrid vehicles.

In module 61 "Kia/Hyundai CPGDSH/CPEGD", test support has been added for CPEGD3.20.1, CPEGP3.20.2, CPGPSH3.24.1, CPGPSH3.26.1 ECUs installed in Kia/Hyundai vehicles with 1.6l gasoline engines. Reading, writing and checksum correction are supported.

In module 69 "Mercedes-Benz MED17/EDC17", support for another option for the ME9.7 ECU has been added. Reading, writing and correction of checksums are supported.

The module 72 "Mazda Gen 4" adds support for the Mitsubishi PV10/PV11 ECU installed in Mazda 2 vehicles. Recording and correction of checksums is supported.

In module 77 "Bosch ME9/MED9/EDC7/EDC16/PSG16/TCU Bootloader" improved support for checking and correcting CS for ECU ME(D)9.6.

In module 79 "Mitsubishi CAN-bus Bootloader" improved support for checking and correcting CS for some Suzuki and Mazda ECUs.

The module 80 "Denso SH725xx/1N83M Bootloader" has improved support for checking and correcting CS for the ECU of FAW vehicles.

Module 89 "China MG1" adds support for the MG1US008 ECU installed in DongFeng vehicles. Recording and correction of checksums is supported.

Support for the Delphi DCM7.1 ECU used in Changan vehicles has been added to module 90 "China DCM6.2AP/DCM7.1AP". It supports reading, writing and correcting checksums, as well as working with EEPROM.

Support for the VD1CC001 ECU using the SPC574K microcontroller has been added to the Bosch MD1/MG1 Bootloader module 92.

In module 93 "India DCM7.1AP", work with the DCM2.5 ECU has been improved, and support for the Delphi DCM7.24 ECU used in Tata trucks has been added. Read, write, and checksum correction are supported.

The Aisin TCU Bootloader module 94 adds support for various Aisin automatic transmission control units used in Mazda, Changan, GAC, Suzuki cars, as well as those produced by VAG concern.

Other fixes and useful changes.