Module to calibrate the firmware of the control units Bosch MD1 diesel BMW cars. Supports all the necessary maps for tuning, disable the EGR, DPF, and SCR (ADBlue)!
Supported file size 7.5 MB.
A list of available maps:
-
Control air mass: expected mass air flow correction flow
-
Pressure boost: the desired boost pressure, the limit boost pressure, PWM boost controller and its limits
-
DPF: mask of regeneration, flags disable DPF sensor calibration back pressure of the EXHAUST gas, flags, and voltage for error detection
-
EGR: the EGR position correction lower/upper thresholds to enable the EGR in all modes, the maximum EGR position
-
Sensors EXHAUST gas temperature: calibration of all sensors EXHAUST gas temperature, the thresholds of error detection for voltage flags
-
Injection: the opening time of the injectors, the calculation of the mass vpriska of time post-injection, the start angle of the main injection and restriction
-
The pressure in the rail: components of the PID controller, the set pressure in the rail, the limit pressure, the minimum pressure for starting, the pressure regulator in the rail
-
SCR (Adblue): fill/clearing flags for NOx, ADblue injection, lambda control, NSC, LamCtl
-
The composition of the mixture: the composition of the mixture to limit the smoke
-
Torque limit: the main constraints of input and output torque, limiting torque in case of errors, limiting time in the temperature of the EXHAUST gas, fuel, and backpressure
-
Request time: the request time card calculation pedal for modes ECO, Sport, Sport+, reduced the requested time for the coolant temperature and atmospheric pressure
-
Mask errors
We perform fast worldwide shipping and PayPal payments
We provide a guarantee for products and technical support
Our system of discounts and regular promotions save your money
