Bosch MSE8.0

Module description

Module for editing Bosch MSE8.0 calibrations in powersports vehicles by CFMoto, Sinnis, Dayang, Kove, Zontes and other manufacturers.

Available maps

• Air Calculation: Inversed pedal characteristic map; Mass air flow through throttle valve at idle; Target air filling; Mass air flow intake temperature correction factor
• Dwell: Dwell Time (Charge Coil)
• Engine speed limitation: Engine speed limitation in additional mode
• Fan control: Fan control sensor; Fan control temperature
• Fuel: Acceleration and deceleration enrichment factors; Fuel enrichment at warm up 1; Post start enrichment factor; Share factors for acceleration and deceleration enrichment; Temperature factor for air throttle valve
• Lambda: Lambda for component protection; Lambda efficiency; Target lambda at full load
• Spark Advance: Minimum spark advance; Optimal spark advance; Spark advance angle; Spark advance efficiency by delta ignition angle
• Temperature: Exhaust gas temperature
• Throttle Control: Mass air flow through throttle valve control; Maximum throttle position
• Torque: Engine drag loss torque; Optimum torque; Torque limitation
• Vehicle speed: Vehicle speed limiters when found; support is not guaranteed
• DTC: Diagnostic trouble code handling

A BitEdit protection dongle is required.

Write a review

Your Name:


Your Review:

Rating: Bad           Good

Enter the code in the box below:

Write a review

Write review