Bosch MSE9.0

Module description

Module for editing Bosch MSE9.0 calibrations in powersports vehicles. Supports 6 MB files; maps are available for Flash 0 and Flash 1.

Available maps

• Air Calculation [Flash 0 & Flash 1]: Inversed pedal characteristic map; Mass air flow through throttle valve at idle; Target air filling; Mass air flow intake temperature correction factor
• Dwell [Flash 0 & Flash 1]: Dwell Time (Charge Coil)
• Engine speed limitation [Flash 0 & Flash 1]: Engine speed limitation in additional mode
• Fan control [Flash 0 & Flash 1]: Fan control sensor; Fan control temperature
• Fuel [Flash 0 & Flash 1]: Acceleration and deceleration enrichment factors; Fuel enrichment at warm up 1; Post start enrichment factor; Share factors for acceleration and deceleration enrichment; Temperature factor for air throttle valve
• Lambda [Flash 0 & Flash 1]: Lambda for component protection; Lambda efficiency; Target lambda at full load
• Spark Advance [Flash 0 & Flash 1]: Minimum spark advance; Optimal spark advance; Spark advance angle; Spark advance efficiency by delta ignition angle
• Temperature [Flash 0 & Flash 1]: Exhaust gas temperature
• Throttle Control [Flash 0 & Flash 1]: Mass air flow through throttle valve control; Maximum throttle position
• Torque [Flash 0 & Flash 1]: Engine drag loss torque; Optimum torque; Torque limitation
• Vehicle speed [Flash 0 & Flash 1]: Vehicle speed limiters when found; support is not guaranteed
• DTC: DTC

A BitEdit protection dongle is required.

Write a review

Your Name:


Your Review:

Rating: Bad           Good

Enter the code in the box below:

Write a review

Write review