Nissan Hitachi Petrol Turbo Gen1

Module to calibrate the firmware of the control units Hitachi Gen1 petrol turbocharged Nissan (Juke 1.6 T Tiida 1.6 T, GTR).

Supported file MCU Renesas SH7058 size 1.0 MB.

Available the following cards:

The specified boost pressure, multiplier to limit and boost cut-off, the calculation of the relief valve of the boost from the speed and pressure, given a PWM for valve control the boost, the estimated temperature of the catalyst, the fuel in the regulatory regime, the enrichment at partial load and at full load, coeff. gain for oxygen sensors, the compensation of fuel injection when opening the throttle curves to: oxygen sensor, sensor mass air flow, open the throttle pedal, the calculation basis QH0, backstraps advance angle for the high and low octane, base trimming angle, the optimum angle for low and high octane, the minimum advance angle, the sensitivity of the knock sensors, the estimated engine torque, converting QH0 at the moment, the force in the actuator, the maximum and minimum power to drive, the Rev limit and speed limit (if found). Mask errors are also available.