Trucks/Industrial Delphi ETC3

Module description

Module for editing Delphi ETC3 ECU firmware in diesel trucks and industrial vehicles. Supported makes include DAF, Kenworth, Peterbilt and Tatra; Hyundai is not supported.

Available maps

• Air Calculation: Desired air mass flow; Expected air mass flow; Maximum desired airmass flow; Minimum desired airmass flow
• Boost Pressure: Air pressure; Boost limitation; Pressure loss adjustment; Reference value for air boost temperature; Boost pressure sensor; Pressure injection correction factor; Correction factor for air mass flow threshold in overflow based; Correction factor for air mass flow model on idle based
• DPF: Cold engine factor on DPF regeneration state; Maximum fuel value of DPF regeneration state; Fuel limit for DPF fault; Reference engine speed setpoint for standstill DPF regeneration
• EGR Control: Ambient pressure correction for maximum EGR position; Discharge offset based on EGR position; Maximum EGR position; Minimum EGR position; Open loop control EGR position; Fuel limit for active EGR; Maximum and minimum allowed voltage for EGR actuator driver
• Exhaust temperature sensors: Exhaust temperature upper/lower limit; Maximum exhaust temperature; Minimum exhaust temperature
• Fan Control: Fan control (for test)
• Fuel: Fuel limitation; Fuel value for enabling condition in ignition mode; Smoke fuel limit under cold engine conditions; Threshold fuel value and engine speed map for AMF governor deviation; Maximum fuel limitation; Minimum fuel limitation
• Injection: Injection rate; Injection timing efficiency loss
• Lambda: High/low threshold input lambda variation; Lambda reference data at cold/hot temperature; Learn operation area of lambda; Maximum value calculation factor for lambda limiter; Minimum value calculation factor for lambda limiter
• Limiters: Engine speed limitation; Vehicle speed limitation (for test)
• NOx: NO2/NOx ratio; Power function for virtual NOx calculation; Reference value of NOx for cold/hot conditions; Variable exponent for power function for virtual NOx calculation
• Rail pressure: Base rail pressure; Maximum rail pressure demand compensation
• SCR (AdBlue): Maximum permissible temperature limit after SCR; Minimum SCR inlet temperature to disable SCR high efficiency modes; Reference value of O2 for cold conditions
• Torque: Base primary retarder torque; Electric fan torque contribution; Maximum achievable torque data; Mechanical fan torque contribution
• Volumetric efficiency: Volumetric efficiency reference
• DTC: Diagnostic trouble code handling

A BitEdit protection dongle is required.

Write a review

Your Name:


Your Review:

Rating: Bad           Good

Enter the code in the box below:

Write a review

Write review